To choose the optimal model from our wide selection, we recommend selecting based on your desired specifications, such as whether it is "HFC alternative," "energy-saving," "drain-free," or "filter-less," as listed in the lineup and specification below.
However, please note that your desired installation method may not be available under the selected conditions.
HFC alternative type (not subject to the Fluorocarbons Emissions Control Law)
Conventional Enclosure Cooling Unit typically use "fluorocarbons" or "alternative fluorocarbons" as refrigerant, but Apiste has developed the industry's first Enclosure Cooling Unit using "HFC alternative."
refrigerant R1234yf used in Apiste 's HFC alternative Enclosure Cooling Unit ozone depletion potential (ODP) of 0 and a global global warming potential (GWP) of less than 1, making it an environment friendly refrigerant. Furthermore, it is exempt from the Fluorocarbon Emission Control Law, eliminating the need for periodic full inspections, record keeping, and obligations regarding the recovery and destruction of CFCs.
HFC alternative type lineup
A state-of-the-art, HFC alternative, low-maintenance, and energy-saving Enclosure Cooling Unit
The ENC-GR-Pro series of Enclosure Cooling Unit Enclosure Cooling Unit is Apiste 's latest model, featuring non-freon-gas refrigerant, filter-less requiring no maintenance for extended periods, and energy savings thanks to its built-in inverter.
Energy-saving type
Energy-saving (inverter-equipped) type
Unlike conventional Enclosure Cooling Unit which use ON/OFF control, Apiste 's energy-saving Enclosure Cooling Unit inverter control so they do not operate at full capacity until the load reaches 100%, thus reducing running costs.
Furthermore, because there are fewer temperature fluctuations when cooling is stopped, similar to ON/OFF control, stress on electronic devices is reduced.
power consumption comparison data *For ENC-GR1500L-Pro
[operating conditions] ambient environment: 35℃-40% cooler setting temperature: 35℃
power supply frequency: 60Hz
Energy-saving inverter-equipped type lineup
Energy-saving intermittent operation
Eco mode equipped type
If compressor continues to operate in cooling mode for 30 minutes, it will switch to fan mode for 5 minutes. (The initial setting is for compressor to operate continuously until the temperature inside the panel drops.)
Cooling fan eco operation
The cooling fan will also turn on/off in sync with compressor 's ON/OFF operation.
(The initial setting is for the cooling fan to run continuously regardless of compressor operation.)
Filter-less
Conventional Enclosure Cooling Unit use fin and tube type condensers for heat dissipation, so if they become clogging with dust or other debris, their cooling capacity will decrease significantly, making regular maintenance of filter and fins essential.
Apiste 's ENC-GR-Pro series is the industry's only finless type, meaning there are no parts that can clogging, eliminating the need for filter and allowing it to maintain cooling capacity for extended periods.
filter-less type lineup
Drain-free and no heater
The special vaporization filter which is non-flammable and has excellent water absorption and breathability, holds the drain water, and vaporizes the drain water using only the heat exhausted by cooler without consuming extra electricity.
Recommended for use in mezzanines and other locations where drainage is difficult. (drain-free conditions: 35℃/85%)
Drain-free type lineup
Outdoor specification
To ensure high durability, the unit is designed environment outdoor installation or use in wet and humid environment such as food factories, with an all-stainless steel body, a condenser finished with cathodic electrocoating, and refrigerant piping finished with modified epoxy resin coating.
outdoor specification lineup
Other lineup
Side-mounting
This type is attached to the side and door of panel.
Ceiling Mounting
This type is installed on the ceiling of panel. The ceiling type has a double drain pan structure to prevent water from leaking into panel.
AC100V specification
Please note that some models/ model do not support AC100V.
If you only have AC 100V, consider using a step-up transformer.
Small and slim type
We also offer compact and slim-body Enclosure Cooling Unit installation in small panel or in locations where space is limited and installation is difficult. You can choose the model that best suits your installation location.
